1 1

50 FT OF 1/8" X 1/4" FUEL TUBI

50 FT OF 1/8" X 1/4" FUEL TUBI

$88.75
$88.75
Sale Sold out

The 50 FT OF 1/8" X 1/4" FUEL TUBI is a marine-grade fuel tubing designed to safely deliver fuel from tank to engine in boats, generators, and small engines. Stocked by GodsMods, this hose meets USCG and ABYC standards for below-deck fuel systems in gasoline-powered vessels.

Manufactured from a synthetic rubber inner tube reinforced with textile braiding and a nitrile/PVC cover, this 1/8-inch by 1/4-inch fuel tubing is rated for continuous exposure to gasoline, diesel, ethanol blends, and biodiesel. The hose meets SAE J1527 standards with a working pressure of 50 PSI and burst pressure exceeding 200 PSI.

Critical for safe fuel system installations in boats, the hose's low permeation rate minimizes fuel vapors in enclosed compartments. Replacing aged, cracked fuel hoses with this USCG-approved tubing is an essential safety maintenance task for any gasoline-powered vessel.

Shop with confidence at GodsMods
View full details

Frequently Asked Questions

What material is the Atech hose made from and what fluids is it compatible with?

The Atech hose is constructed from synthetic rubber or PTFE with a braided reinforcement layer depending on the specific product. It is compatible with gasoline, diesel, ethanol blends, oil, and coolant within the rated temperature and pressure range. The Atech hose is rated for operating pressures up to 200 to 300 PSI and temperatures from -40 to 300 degrees Fahrenheit. Always verify the fluid compatibility and pressure rating of the Atech hose for your specific application.

Can I use the Atech hose for both fuel and oil systems in my vehicle?

The Atech hose is suitable for both fuel and oil systems as long as the temperature and pressure ratings match your requirements. For fuel injection systems ensure the Atech hose is rated for high-pressure applications typically 50 to 100 PSI. For oil systems verify that the Atech hose can handle continuous exposure to hot engine oil without degradation. Using the correct Atech hose specification for each fluid type ensures long-term reliability.

How long will the Atech hose last in a daily-driven performance vehicle?

The Atech hose has an expected service life of 5 to 10 years in a daily-driven vehicle when properly installed and maintained. The synthetic rubber construction resists ozone cracking and fluid degradation better than standard rubber hoses. Regular inspection for cracks, swelling, or abrasion will help identify replacement needs before a failure occurs. The Atech hose life can be extended by using protective sleeving in areas with high heat or abrasion exposure.

What fitting sizes and AN sizes are available for the Atech hose in my plumbing setup?

The Atech hose is available in sizes from -4AN up to -12AN depending on the specific product line. Common sizes for fluid systems are -6AN for most street applications and -8AN for high-flow builds. The Atech hose uses standard AN flare fittings that seal on the 37-degree flare surface. Measure your existing fitting sizes and flow requirements to select the correct Atech hose diameter for your system.

Does the Atech hose require special tools for cutting and installing fittings?

The Atech hose can be cut with a sharp utility knife or a dedicated hose cutter for clean square cuts. Push-lock Atech hose requires no special tools beyond a clean straight cut for installation. Braided stainless Atech hose requires a vise and wrench set for tightening the AN fittings. A hacksaw with a fine blade works for cutting braided hose but wrap the cut area in tape to prevent fraying.